Gear and slin pins

hi guys,

currently due to start my 4th cycle which will be test prop @50mg ed and tren ace 50mg a day. this will be my first cycle usin ed shots, previous cycles were all enanthate esters.

the gear that i have is dosed at 100mg each per ml, so .5ccs of tren and .5ccs of test prop mixed together would be 1cc a shot, and i know this will just about fit into a slin syringe. i know the thicker oils would not stand a chance of going through the small needle but with acetate and prop esters i think it will be ok? please correct me if wrong.

i have very low bf so would be injecting into quads and delts, i dont think needle depth should be a prob, any feedback from guys who have used slin pins for injecting gear would be very much appreciated. have read on some american forums ppl using slin pins, but the yanks are full **** :) 

dont have a problem with jabbing but not done ed before, just want it to be as comfortable as poss with minimum scar tissue and muscle trauma.

what do you guys think?

twiggystyle 

You would want to draw up from the amp/vial using the green needle and barrel as per normal, put in slin pin and then inject

It would take an age to draw using the slin pil, not to mention blunting the tip. I am using Sus, but have used prop and both will work fine.

Use it at moment, saves on nerve and tissue damage.

thx chrisla,

where have you been injecting and did you find it took ages to administer using a slin pin? also did you warm the gear up first?

thx, twiggystyle

Tris and delts I use, 1ml will come out fairly quickly. Its the drawing up which takes the time, which is why I suggested drawing it using another needle and then putting it into the slin pin.

Sterility of utmost important as per usual and keep the slin pin open for the gear for minimum amount of time so as few pathogens as possible get in.

agree on the importance of sterility mate, good to hear positive results using sln pins, really excited about my cycle now 

thx for the response,

twiggz

i had no idea that you can use slin pins for fast esters! that kind of makes the idea a little bit more tempting for me.

wannagetbigmatt


i had no idea that you can use slin pins for fast esters! that kind of makes the idea a little bit more tempting for me.

deffinatley!