ORIGINAL: PartyBoy
ORIGINAL: lewism6
30g are the slin pins arent they?
Yes, though slins tend to be shorter than a regular 30g 0.5" pin.
i was intending on buying the 30g pins just wanted to know if they would fit on the 3ml barrel and that the 3ml barrel would be ok for injecting the solution out of?
Yes they will fit. Barrels and needles are a universal size. As said though, 3ml barrels will not provide a great deal of accuracy without using a large amount of dilutent. 2ml barrels would be ok though
Having just started my MT2 yesterday, I agree that the 30g pins at 0.5" length are fine for the SQ jab. I have got 2ml barrel and I only just managed to measure out my first 0.1ml dose, today was okay at 0.2ml... but still fiddly. 1ml barrels would be ideal
As PB says somewhere in this post, draw back the plunger after your shot, so as to reclaim the unused MT2, as there there tends to be a bit more unused stuff in there than there would be in an "all in one slin pin".
Start your doses low guys to test your side effect levels ;) .
I would have diluted my 10mg MT2 powder to 4ml of boc water as PB suggests but I couldn't physically fit 4ml into the vial... go figure. So I've diluted to 2ml instead, which is fine... particularly when you get to the 1mg level and it's to the 0.2ml mark on the barrel.
Side effects haven't been too bad for me... nausea for a few hr, but hey no sickness so no biggie. After about 3hrs after my shot I suffered some recurring hardons... not good in the office, lol... longer shirt tomorrow. But, they subsided after about 4 hrs. Upon reflection, I think I'll take my shot before tea from now on... let my GF have some benefits
Have fun tanning