quote:

ORIGINAL: mad_cereal_lover

quote:

ORIGINAL: mado01a

anybody have an idea why it hurts sometime, could it be because what ur injecting is dangerous, fake or not that steril ?

well known UGL still sell real stuf, some better than other but the fact that some hurt should be a reason good enough to stop it ???
thanks

Your answer lies with comparing pharma prop to UGL prop:

Pharma prop = never over 50mg/ml
UGL prop usually minimum 100mg/ml

Prop has a very high melting point and thus is not nearly as soluble in oil as things like test enanthate etc. Even tren acetate (acetate being shorter ester than propionate) is more lipid soluble (ie. dissolves better and easier in oil) than test prop. Just the nature of the compound but generally shorter esters = less solubility. Thus by dissolving 100mg of test prop per ml, just using BA, BB and oil, you are just reaching the saturation point of prop - this can be adjusted a bit by adding more BA and BB so you can dissolve more. However, the solvents like BA especially and BB will once in the body be absorbed out of solution much more quickly so if your test prop preparation is relying on some of these solvents to stay in solution, they leech out of the muscle leaving prop behind at a high concentration which will form crystals, which = PAIN in muscle where crystallisation occurs. These crystals will break down slowly over time, thus a bit of time for pain to go.

Certain oils and solvents such as ethyl oleate can be used which increase the solubility of the hormone and "stay" with the hormone in the muscle and do not leech out like BA and BB do. EO is more expensive than oil and not often used in UG lab preps, although even Farmak prop which is pharma and uses EO as a carrier is STILL only 50mg/ml IIRC!

mcl

quote:

dazc
Pro-Member

Status: online what concentration was it?

there was a reason that pharma prop came in 50mg/ml

quote:

ORIGINAL: Papa Lazarou

Thing is tho IMO EO aint something you really want large amounts in you tho.